The Gas Detection System at S4 of the FRS
Main

Gas detection at S4

ArCO2
 Instruction
 Configuration
Low Pressure

          Operat. Mode

          Calibration

P 10
 Instruction
 Pictures

CF4
 Instruction
 Pictures

H2

New LH2-Targets

Start of LH2-Target S0
 Change to LD2
 Turn off LH2-Target S0
 Alarm
 Pictures

Contacts

Links and

          Downloads

 

 

Holger Pfeifer

       September 2003

 

 

 

 

 

At S4 of the FRS a Gas Detection System for CH4 and H2 is installed.

This system is of the type Winter GMS 8 and consists of two modules and two sensors for H2 and one module and one sensor for CH4.

The system is installed left-handed of the entrance to S4 at the wall and the sensors are installed at the ceiling of S4.

The H2 sensors are at the time out of operation due to the lifetime of these sensors: approx. 12 months.

 

These H2 sensors must be renewed before using the H2 at S4 again!

 

The alarms of these modules are given to an alarm module. If the gas concentration either H2 or CH4 exceeds 10% of the metering range, an alarm appears optically and a buzzer resounds. A reset of the alarm can only be done at the alarm unit after the reason of this alarm is eliminated.

 

 

In the case of an Alarm follow strictly all Safety Instructions for burnable gases!

 

 

Detailed manual for the GMS 8(*.pdf-file) in English or German see Links and Downloads.

 

 

 

 

 

K.Burkard 30.09.03